SR14
Dual Fan Kit
Please read these instructions carefully and follow
the installation steps in sequence.
Tools Required
Phillips head screwdriver
5”Fan Panel
CLIP NUT INSTALLATION
Rail
.5”
Clip nuts provide mounting points on 19" rack mount
equipment rails.
Use this hole
.625”
Clip nuts have a front or screw side. Consider which
way it should face for ease of access to the screwhead
during component installation. (see figure 1)
.625”
.5”
.625”
To remove a clip nut from a rail, insert a flat blade
screwdriver or knife under the tab on the front and
pry up, freeing the retainer ring from the rail.
Clip nuts
.625”
.5”
1. Select the location at which the fan panel will be
installed in the enclosure.
Use this hole
.625”
.625”
.5”
2. Install one clip nut into the top hole at the selected
position and then install another one six holes down.
(see figure 2)
Rail
Figure 1
3. Measure from the bottom of the vertical rail to the top
clip nut. Assemble the clip nuts onto the opposite rail
at the measured height.
Figure 2
Rails
4. Assemble the Fan Panel to the rails with the 10-32 x 1/2
phillips head screws. (see figure 3)
10-32 x 1/2 phillips
Clip nuts
Cord
Figure 3
Manual Part #93-1865
07/09/02 rev. A
1
|
Targus MP3 Docking Station ACP60 User Manual
Toshiba DVD VCR Combo D VR3SU User Manual
Toshiba Network Card A8 EZ8511 User Manual
Toshiba Rice Cooker RC 10NMF User Manual
Toshiba Tablet AT305SE T16 User Manual
Triarch Indoor Furnishings 75360 10 User Manual
Uniden Headphones DCX170 User Manual
Uniflame Outdoor Fireplace WAD1081W C User Manual
Verona Range VEFSGG 244 User Manual
Viper Automobile Alarm 160XVL User Manual